#Rowe ami r 87 manual manual#
Rowe AMI R-89 Sapphire 89, Golden 89 (1985) Manual Buy now. AMI / Rowe R-88 Service Manual, Parts Lists & Troubleshooting Guide Complete sequence of operation schematics in COLOR Buy now. carousel spins and stops when it's supposed to. Rowe AMI R-87 7 Sapphire, Golden 7 (1983) Manual Buy now. I posted this in another topic, but the terminal is from TE connectivity / AMP, part 3-640707-1 contact, receptacle, 24-18AWG, crimp ( ) and it's a perfect fit. I pushed out the terminal in slot 10 and two pieces fell out:Īs before, I was unable to uncrimp the wire, so I just snipped the crimps off and luckily my order of new terminals had just arrived in the mail today, so I just crimped on the new terminal. The manual tells me that slot 10 is the optical switch index connection. When I put a jeweler screwdriver into slot 10, I got encountered no resistance compared to any of the other slots. However, when I closely inspected each of the slots in the molex connector on the Mechanism Control board side, I noticed that I could see a bit more light coming through slot 10. I had nearly zero resistance readings plugging my multimeter leads into each of the slots on either end of the CCC to Mechanism Control connection. solid Detent and Magazine Motor lights, flashing Opt SW index and occasionally flashing Opt SW Home. I was pretty convinced that the problem lay somewhere in the connection between the CCC and Mechanism Control board, especially since I was getting all the right flashing lights while the carousel was spinning, i.e.
#Rowe ami r 87 manual crack#
While desoldering, its neighbor started to crack open a bit as well, so I replaced that one, too: I guessed that probably wasn't the problem, but I replaced it anyway. Not terrible, but outside of the 5% tolerance. The multimeter reading across the resistor was 1075 ohms. I noticed that one of the resistors was looking a little not-so-fresh: I next took a closer look at the Mechanism Control board. No obvious cold joints, but I resoldered all of the connections to the Mechanism Control board connecter, just to be safe.
#Rowe ami r 87 manual tv#
I haven't got any experience with jukebox repairs, but have repaired a lot of electronics like TV sets. Next, for good measure, I pulled the CCC and checked all the solder joints. Hi, does anyone have a scanned service manual or schematic for AMI ROWE R87 The problem is that it won't play any record, it let's you select the song but then nothing happens. So I solder-sucked that joint, as well as all of the other joints on the connector, just to be safe, and reflowed fresh solder at all of the joints.
Lo and behold, I found an honest-to-goodness cold joint: I pulled the Mechanism Control board and took a close look at the solder joints at the plug connection. For future reference, I'll detail my process hereĮventually, wiggling the CCC-to-Mechanism-Control plug stopped working and the carousel started spinning endlessly again. Finally, after much hair-pulling and many red herrings, I finally solved the non-stop spinning carousel issue.